
MNC-0400-001 36 of 54 REV H
Operation, Rack and Digital HPAs
Setup Menu 5
Setup Menu 5, Figure 15 provides access to the Calibrate
Attenuator and Replace Firmware submenus. This Setup Menu
is to be used by Xicom Personnel only. It is shown here solely
for information.
Figure 15, Setup Menu 5
Fault/Alarm Report Displays
The Alarm Report Displays work in the same way as the Fault Report
Displays discussed in this section. When a fault occurs, the amplifier
sounds an audible alarm (if enabled) and presents a “fault report” on
the amplifier front panel display. Operator action is required to clear
the fault report displays. There are two types of fault report displays:
• Latched Fault Report Displays
• Non-latched Fault Report Displays
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Comentarios a estos manuales