
MNC-0500-002 15 of 36 Revision H
Amplifier Communication and Protocol, Octagon ISA CPU
Commands and Queries
Firmware Information
The following firmware revision is baseline:
TWT Amplifier (all models)3.81
All commands and queries listed herein are compatible with baseline
firmware except where noted.
Note
Certain commands and queries require that special options
be present in your unit(s). For example, an amplifier
without an attenuator will reject command ‘C’: “Set
Attenuator.” In the Commands and Queries in this section,
compatibility issues are noted when relevant.
Table 7 provides the operators and technicians a list of the amplifier
queries and pages available for use.
Table 8 provides the operators and technicians a list of the amplifier
commands and pages available for use.
Table 7, List of Amplifier Queries
Query Page
ID/Version 17
Summary Status 18
Fault Status 19
Fault History 19
Current Screen 20
Power in dBW 20
Power in Watts 20
Attenuator Counts 20
Alarm Condition 21
Advanced Query 22
Get Serial Configuration 25
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Comentarios a estos manuales