Comtech EF Data UT-4514F Especificaciones descargar pdf (Pagina 77)

UT-4500-A Series Upconverters Revision 1

Front Panel Operation MN-UT4500A

5–9

5.3.1.3 CONFIG: REDUNDANCY

1:1 Redundancy is an optional feature for the UT-4500-A. If you attempt to select any feature from

this menu branch, and either Redundancy Configuration is off or the upconverter is the primary

operating unit, the Redundancy menu branch appears as follows:

Redundancy: MODE

Otherwise:

Redundancy: MODE

Auto/Manual FORCE HSB

Use the

◄ ► arrow keys to select MODE, Auto/Manual, FORCE, or HSB (High Speed Bus), and

then press ENTER.

Note: If any submenu is selected from this menu branch when the unit is not in Local Mode

(i.e., the unit is in either Serial or Ethernet Remote Mode), the system prompts you to switch or

Local Mode as follows:

Remote Mode: press ENTER

for local mode, or CLEAR

Operations may continue once Local Mode is established.

CONFIG: REDUNDANCY  MODE

Redundancy Config = On

CONVERTER = #BU 1:01

On the top line: First, use the

◄ ► arrow keys to navigate to the Redundancy Config

setting, and then use the ▲ ▼ arrow keys to set operation as On or Off.

On the bottom line: First, use the

◄ ► arrow keys to navigate to the Converter Selection

setting, and then use the ▲ ▼ arrow keys to toggle the upconverter operational preference

as #BU or #01. Note the following:

• With CONVERTER = #BU, the unit is set as the standby, or backup unit. This mode of

operation is indicated on the right-hand side of the bottom line as 1:01.

• With CONVERTER = #01, the unit is set as the primary operating unit. The mode of

operation is indicated on the right-hand side of the bottom line as POL=1.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 161 162

Sin comentarios

Comtech EF Data UT-4514F Especificaciones Pagina 77