
UT-4500-A Series Upconverters Revision 1
Appendix A MN-UT4500A
A–9
A.7.1.7 IP Address
Use the IPA command to set the IP address and network prefix for the 100BASE-TX Ethernet
management port. The factory default value is 192.168.1.4.24.
<DEV/IPA_aaa.bbb.ccc.ddd.yy'cr’
Where:
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255, but they cannot all be zero.
yy is the Subnet Mask Length (range: 8 to 30)
>DEV/IPA_ aaa.bbb.ccc.ddd.yy'cr'lf']
>DEV/IPA_ aaa.bbb.ccc.ddd.yy'cr''lf']
A.7.1.8 IP Gateway
Use the IPG command to set the IP gateway address for the Ethernet management port. The
factory default value is 192.168.1.5.
<DEV/IPG_aaa.bbb.ccc.ddd'cr’
Where:
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255, but they cannot all be zero.
>DEV/IPG_ aaa.bbb.ccc.ddd'cr'lf']
>DEV/IPG_ aaa.bbb.ccc.ddd'cr''lf']
A.7.1.9 Physical Address
The default physical address is 001.
<DEV/SPA_xxx'cr' xxx = 1 to 255
Comentarios a estos manuales