
UT-4500-A Series Upconverters Revision 1
Appendix A MN-UT4500A
A–8
A.7.1.4 Time Protocol Server
Use the TPS command to set the Time Server IP address for the Ethernet management port in the
format xxx.xxx.xxx.xxx.
Set Time Protocol Server:
<DEV/TPS_xxx.xxx.xxx.xxx'cr’
Where:
xxx.xxx.xxx.xxx is the Time server IP address.
>DEV/TPS_xxx.xxx.xxx.xxx'cr'lf']
>DEV/TPS_xxx.xxx.xxx.xxx'cr''lf']
A.7.1.5 Local / Remote Status
Use the LRS command to enable or disable remote communications interfaces. The factory default
setting is 3 (Ethernet and Serial remote control enabled).
Status:
Where:
x=
0 for front panel control only (remote control disabled)
1 for serial remote control
2 for Ethernet control
3 for Ethernet and serial remote control
A.7.1.6 Media Access Control (MAC) Address
Use the MAC command to query the unique MAC address of the unit’s Ethernet management
port.
>DEV/MAC_xx-xx-xx-xx-xx-xx'cr''lf']
Where:
xx=MAC address byte in hexadecimal
Comentarios a estos manuales