
UT-4500A Series Upconverters Revision 1
Introduction MN-UT4500A
1–5
Local operator input commands and the status of the upconverter are displayed on the front
panel Vacuum Fluorescent Display (VFD) on the front panel.
An upconverter fault is indicated by the LED indicator on the front panel. Specific fault
conditions are displayed on the VFD through local keypad input commands.
1.3 Upconverter Features
1.3.1 Physical Description
The UT-4500-A Series Upconverter’s 1RU-high (1.75”) 19-inch wide chassis is designed for rack
mounting into a standard 19-inch (48.26 cm) equipment rack. Handles installed on the front
panel provide ease of installation into and removal from the equipment rack. The unit may also
be mounted into the rack using the provided slide mechanisms to allow service without removal
from the rack.
For: See:
• Rack installation and mounting
instructions
Chapter 2. INSTALLATION
• Local operating instructions and
procedures
Chapter 5. FRONT PANEL OPERATION
• Remote control operating
instructions and procedures
Chapter 6. ETHERNET-BASED REMOTE
PRODUCT MANAGEMENT and
Appendix A. REMOTE CONTROL
Redundant system operating
instructions and procedures
Appendix B. REDUNDANT SYSTEM
OPERATION
Maintenance and
troubleshooting procedures
AND
TROUBLESHOOTING
Comentarios a estos manuales