Comtech EF Data Vipersat CDM-570 Guía de usuario descargar pdf (Pagina 90)

Vipersat Configuration

3-54 Vipersat CDM-570/570L User Guide

If the FAST feature key for Management Security has been purchased for the

target modem, then it will appear as a menu item on the Vipersat Configuration

screen (figure 3-6).

Enter K at the command prompt to configure this feature, as shown in

figure 3-72, below.

Figure 3-72

Vipersat Management Security screen

Enter M at the command prompt to toggle between Enabled/Disabled.

Note that the feature must be set to Enabled in order to configure the encryption

key.

Enter K at the command prompt and Enter the required key (figure 3-73).

(Following entry, the characters will be temporarily displayed in the menu for

reference purposes.)

Figure 3-73

Encryption Key Entry prompt

Enter V at the command prompt and re-enter the same key to Verify it.

(Following entry, the characters will be temporarily displayed in the menu for

reference purposes.)

Enter G at the command prompt to execute the verification process and Gener-

ate the hex key.

The Future Key menu item will display Valid to indicate successful verification

of the key and that it is ready for activation.

Enter A at the command prompt to Activate the key for current use.

The Current Key menu item will display Valid to indicate successful activation.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 191 192

Sin comentarios

Comtech EF Data Vipersat CDM-570 Guía de usuario Pagina 90