Comtech EF Data Vipersat CDM-570 Guía de usuario descargar pdf (Pagina 35)

Chapter 2 - Quick Start Configuration 2-11

Initial Configuration

Set the Vipersat Configuration

1. Enter V at the Main Menu command prompt shown in figure 2-1 to select

the Vipersat Configuration menu shown in figure 2-9.

Figure 2-9

Vipersat Configuration screen (Hub)

2. Enter R at the command prompt to toggle the Unit Role to either Hub or

Remote.

This parameter will determine the role the target CDM-570/570L will per-

form in the network and what type of commands and functions it will

receive from the VMS.

3. Enter E to set the Expansion Unit value (Yes or No).

When configured as an expansion unit, either as a hub (switched) or as a

remote (mesh), the CDM-570/570L is set up so that the demod is in SCPC

mode and available as a resource for dedicated communications with the

other end of the satellite link.

4. Enter B at the command prompt to set the Network ID.

The Network ID that is assigned to the unit defines to what network the

target CDM-570/570L will belong. All units used in a network will have

the same Network ID. This parameter is used by the VMS to identify units

common to a network and allows the VMS to manage multiple networks,

each with its own unique network ID number.

5. Enter N at the command prompt to set the Unit Name.

6. Enter V at the command prompt to set the Receive Multicast Address.

This IP address is the multicast address assigned to the VMS and to all

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 191 192

Sin comentarios

Comtech EF Data Vipersat CDM-570 Guía de usuario Pagina 35