Comtech EF Data DMD-2050E Especificaciones descargar pdf (Pagina 273)

DMD2050E Universal Satellite Modem TCP/IP Ethernet Setup

MN-DMD2050E Revision 2 F–3

and loop back addresses will not be allowed. Example Server IP Address setting:

172.018.004.250.

ROUTER IP ADDR: This allows for the setup of the Network Router IP Address. If a router is

present on the local network, and it is to be used, this address must be consistent with the IP

Address Mask and the subnet of the modem. If no router is present, then the address should be

set to a foreign address. Broadcast and loop back addresses will not be allowed. Router not

used example: Router IP Address setting: 010.000.001.001.

MODEM EADDR: This displays the Modem (Unit) Ethernet Address. The Modem Ethernet

Address is configured at the factory. It is a unique Radyne equipment identifier Address.

Example: 0010650903EB

ETHER RATE: This displays the current Ethernet port data rate. If multiple rates are available,

then a selection can be made to specify the Ethernet port data rate (10BaseT). Example

Ethernet port Data Rate: 10 MBPS/HD

F.3 Network Configuration Summary

If the above steps were followed and the information was entered, then the following would be the

TCP / IP configuration summary for a ‘no router specified’ setup:

1. Boot Mode = NON-VOL

2. Bootp Server Tag = 206

3. Modem Host= DMD20

4. IP Address Mask = 255.255.0.0

5. Modem IP Address = 172.18.100.215

6. Server IP Address = 172.18.4.250

7. Router IP Address = 010.000.001.001

8. Modem Ethernet Address= 0010650903EB

9. Ethernet Rate = 10 MBPS/HD

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 341 342

Sin comentarios

Comtech EF Data DMD-2050E Especificaciones Pagina 273