
DMD2050E Universal Satellite Modem User Interfaces
MN-DMD2050E Revision 2 4–25
The CBER display shows an estimated corrected bit error rate of the modem.
Depending on the symbol rate the modem is running, the high-end
performance scale of this display will vary (10 E
-9
, 10
-10
or 10
-11
). At some
symbol rates, a better than scale reading will appear as 0.0 x 10
-00
. At other
symbol rates, it will appear as E**. In either case, they both mean performance
is better than the scale upper limit.
See VOLTAGES (menu)
{0 – 100%}
Displays the status of the Doppler Buffer.
Press ENTER to re-center the Doppler Buffer.
Displays the estimated channel error rate (before decoding) measured by the
modem. (Viterbi and Trellis only)
Displays the current error count from the Viterbi Decoder.
(NOT DISPLAYED FOR TPC OR LDPC MODES)
4.4.4.1 LINK STATUS (menu)
When the TERRESTRIAL INTERFACE parameter is ETHERNET, these additional
status items are visible. See also TX SETUP (menu) or RX SETUP (menu).
Displays the total number of Ethernet packets received from the satellite
Displays the number of erred Ethernet packets received from the satellite
Displays the satellite Packet Error Rate
Press ENTER to reset the Ethernet packet statistics.
Displays the current status of LAN Port 1. See Note.
Displays the current status of LAN Port 2. See Note.
Displays the current status of LAN Port 3. See Note.
Displays the current status of LAN Port 4. See Note.
Displays the current status of the WAN Port. See Note.
Comentarios a estos manuales