
CRS-170A L-Band 1:1 Redundancy Switch MN/CRS170A.IOM
Introduction Revision 13
1–19
1.4 Summary of Specifications
L-Band 1:1 Redundancy Switch
Comtech EF Data, Tempe, Arizona
Supported Comtech EF Data Modems
•
CDM-625A Advanced Satellite Modem with/without optional IP
Packet Processor
• CDM-625 Advanced Satellite Modem with/without optional IP Packet
Processor
• CDM-850 Remote Router
• CDM-840 Remote Router
• CDM-760 Advanced High-Speed Trunking Modem
• CDM-750 Advanced High-Speed Trunking Modem
• CDM-570AL L-Band Satellite Modem with/without optional IP Packet
Processor
• CDM-570L L-Band Satellite Modem with/without optional IP Module
• CDM-710GL L-Band High-Speed Satellite Modem
• CDM-710 L-Band Broadcast Satellite Modem
• CDM-700 L-Band Satellite Modem
• CDM-600L (CLM-9600L) with CRS-150 1:1 Data Switch
•
SDM-300L3 with SMS-301 1:1 Data Switch
•
Fully automatic under control of supporting 1:1 switch.
•
Manual under control of supporting 1:1 switch.
•
Full bridging architecture when supported by CRS-150, or SMS-301
data switching and control, with configuration synchronization.
• Tx redundancy supports all BUC interface signals (RF, 10 MHz
reference, FSK communications, and power supply)
• Rx IF signal fed to both Online and Backup units. Rx switching
supports all LNB interface signals (RF, 10 MHz reference, and power
Tx/Rx switching follows state of supporting data switching via control input
from data switch.
•
Tx IF: Switched by RF relay (1.5 dB max loss, 40 dB min ON/OFF
isolation)
•
Rx IF: Passive power splitting (7 dB max loss)
Switched by power relay (60VDC max, 4A max)
BUC 10 MHz Reference Switching
Switched by relay (1 dB max loss, 70dB min ON/OFF isolation)
Switched by relay (70dB min ON/OFF isolation)
Switched by power relay (28 VDC max)
LNB 10 MHz Reference Switching
Switched by relay (1 dB max loss)
Optimized for 50Ω (> 10 dB return loss on external IF ports)
Ω
Comentarios a estos manuales