Comtech EF Data CDM-710G Especificaciones Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 246
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
4–1
Chapter 4. REAR PANEL
CONNECTOR PINOUTS
4.1 External Connections
Figure 4-1 shows the rear panel view of the CDM-710G High-Speed Satellite Modem. External
cables are attached to connectors on the rear panel. The connector configurations differ based
upon the operating frequency offered via the specific chassis (70/140 MHz [CDM-710G] vs.
L-Band [CDM-710GL]).
Slot 1 Slot 2
Figure 4-1. Rear Panel View (CDM-710G shown w/optional interfaces installed)
Note: The CDM-710G supports Simplex (Tx Only or Rx Only) operation; Duplex (Tx/Rx)
operation; and 1:1 or 1:N redundant operation.
The European EMC Directive (EN55022, EN50082-1) requires using properly shielded cables for
DATA I/O. These cables are double-shielded from end-to-end, ensuring a continuous ground
shield. Table 4-1 summari
zes the connectors provided on the CDM-710G rear panel. Refer to the
applicable Data Interface chapter in this manual for information on, and connector pinouts for, the
available G.703, HSSI, and GigE Data Interfaces.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 245 246

Comentarios a estos manuales

Sin comentarios