Comtech EF Data CDM-710G Especificaciones descargar pdf (Pagina 154)

CDM-710G High-Speed Satellite Modem Revision 1

Telnet Interface MN-CDM710G

9–4

9.3 Using Telnet

Please refer to Appendix A. REMOTE CONTROL in this manual for the syntax and list of

commands and status queries for the modem.

Telnet is implemented in the modem Ethernet M&C in a "Telnet wrapper". When the user Telnets

to the modem, it emulates a local RS-232 (RS-485) serial connection to the modem. The user can

then type the same command syntax that he would use from a serial remote terminal and the

Ethernet M&C "unwraps" the Telnet packet and sends it on to the base modem processor which

responds to it as if it was a serial remote command.

To summarize:

• Start of Packet is either a '<' or a '>' where '<' is used to send a command/query to the

modem and '>' is the modem response.

• Defines the address of the modem (always is 0 in RS-0232).

• The 3 digit instruction code of the specific command/query.

• Instruction Code Qualifier. When sending, = will set a parameter, ? is used to query.

• The modem response will be either =, ?, !, *, #, or ~ (see the specific definitions in

the Remote Control Section).

• Optional argument.

• End of packet (CR).

9.3.1 Telnet Examples

1. A controller sends the following command to the modem to program its Tx frequency:

<0135/TFQ=0070.2345 {CR}

The modem returns:

>0135/TFQ=

2. The message below requests Tx frequency status:

<0654/TFQ?

The modem response is:

>0654/TFQ= 0070.2345 {CR}{LF}

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 245 246

Sin comentarios

Comtech EF Data CDM-710G Especificaciones Pagina 154