Comtech EF Data CSAT-5060 Especificaciones descargar pdf (Pagina 202)

CSAT-5060 C-Band Transceivers Revision 1

Appendix A MN/CSAT5060.IOM

A–6

c) The * code (slave to master) is only used as follows:

i) If the master sends an instruction to set a parameter to a particular value, then, if the value sent in the argument is valid, but the CSAT

will not permit that particular parameter to be changed at that time, the slave will acknowledge the message by replying with (for

example) with UAT* (with no message arguments).

d) The ! code (slave to master) is only used as follows:

i) If the master sends an instruction code which the slave does not recognize, the slave will acknowledge the message by echoing the

invalid instruction, followed by the ! character. Example: XYZ!

e) The # code (slave to master) is only used as follows:

i) If the master sends an instruction code which the slave cannot currently perform because of hardware resource issues, the slave will

acknowledge the message by echoing the invalid instruction, followed by the # character.

ii) This response can only occur if the operator sends two or more hardware configuration type of commands without allowing adequate

time between commands for the hardware to be configured.

Example:

The operator issues commands to change both the up and down converters’ frequencies, with less than

100 milliseconds occurring between commands.

iii) If this response is returned the command has not been accepted and the operator must resend the command.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 223 224

Sin comentarios

Comtech EF Data CSAT-5060 Especificaciones Pagina 202