Comtech EF Data Vipersat SLM-5650A Guía de usuario Pagina 193

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 320
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 192
Appendix B - Antenna Visibility B-5
Using Antenna Visibility
Example — Blocking Spectrum Affected by Local Ground
Frequency Interference
In the example shown here, Antenna Visibility is used to block off a portion of a
bandwidth pool at a given remote site due to ground interference on the lower
part of the transponder spectrum.
In this case, assume there is ground interference on the lower end of the tran-
sponder that overlaps into the bandwidth pool, as illustrated in the figure below.
Figure B-6
VMS Bandwidth Pool with Ground Interference
Note: The satellite spectrum view provided by the VMS, as shown here,
displays the transmit (uplink) carriers from the Hub and the remote sites. The
corresponding receive (downlink) carriers are determined by the frequency
offsets but are not visible.
This interference at the remote site may not affect the transmission path, but
could prevent reception in the lower portion of the pool. With no antenna visi-
bility block, the VMS would perform a switch with this remote, resulting in the
carriers being placed as shown below. This places the corresponding receive
carrier within the ground interference frequency range, and could cause a
disruption in communications.
Figure B-7
Transmit Carriers, No Visibility Block
Vista de pagina 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 319 320

Comentarios a estos manuales

Sin comentarios