Comtech EF Data Vipersat SLM-5650A Guía de usuario Pagina 173

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 320
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 172
Chapter 6 - Out-of-Band Units 6-5
General
Figure 6-6
SNMP Modem Manager
Parameter View
The Parameter View display shown in figure 6-7, displays unit information
and options available for the unit selected in the SNMP Modem Manager. The
following discussion shows the type of information available, but you should
refer to each unit’s documentation for detailed information on setting or chang-
ing any of the parameters listed here.
The options available on the drop-down menu shown in figure 6-7 are:
Apply - Clicking the Apply command writes any changes made to the
unit’s configuration in the Parameter View to the unit’s active memory.
If you want the changes to be permanent, you must save the changes to the
unit’s flash memory.
Revert - If you make a change and want to revert to the previous setting,
clicking the Revert command will revert the setting back to its original
configuration.
Note: If you have marked the changed parameter by clicking the Dirty
Selected command, the Revert command will not function.
Refresh - Clicking the Refresh command will read the current state of all
parameters from the unit and display them in the Parameter View display.
Dirty Selected - If you have made a change, selecting the changed item
and then clicking the Dirty Selected command marks the item as changed
and it will be changed in the unit’s active memory.
NOTE
Vista de pagina 172
1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 319 320

Comentarios a estos manuales

Sin comentarios