
CDM-800 Gateway Router Revision 1
Ethernet-based Remote Product Management MN-CDM800
5–16
5.4.4.2.6 Admin | VMS
The VMS page is operational only when the optional VIPERSAT MANAGEMENT
SYSTEM(VMS)isinstalledandoperational.
VMSv3.x.xVIPERSATManagementSystemUserGuide(CEFDP/NMN/22156)
Figure5‐8.Admin|VMSpage
Vipersat Management System Configuration
Theacceptable/validoperatingrangesforitemsinthissectionareprovidedinparentheses.
• Network ID (1‐255) –The Network ID designation defines to which network the Gateway
Router belongs. All devices in a common network will have the same network ID. The
network ID is used by the VMS to identify Vipersat units within a network and allows the
VMStoma
nagemultiplenetworks,eachwithitsownuniquenetworkIDnumber.
• Management Base Port – The ManagementBase Port sets the startingIP port addressing
forallVMSmessages.
UsethissettingONLYifnetworkportaddressingisincontention.Changestothis
address base affect the entire network, requiring configuration changes to all
modems.
Leave this setting at default (hex) C000 (des) 49152 to avoid unnecessary
configurationchanges.
Comentarios a estos manuales