Comtech EF Data Vipersat SLM-5650A Guía de usuario descargar pdf (Pagina 37)

Chapter 2 - Quick Start Configuration 2-13

Initial Configuration

Set the Vipersat Configuration

1. From the Vipersat submenu, select Vipersat to open the Vipersat

Configuration page.

The example shown in figure 2-9 depicts the page appearance for a Hub

unit.

Figure 2-9

Vipersat Configuration Page (Hub)

The unit Role appearance reflects the Working Mode parameter setting

(see “Set the Vipersat Working Mode” on page 2-5) and identifies the role

of the target SLM-5650A.

2. Enter a descriptor for the Node Name.

This a unit indentifier for operator management that is propagated though

the network up to the VMS. The Node Name will appear together with the

modem icon for each unit in the ViperView client.

3. Set the Network ID.

The Network ID that is assigned to the unit defines to what network the

target SLM-5650A will belong. All units used in a common network will

have the same Network ID. This parameter is used by the VMS to identify

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 153 154

Sin comentarios

Comtech EF Data Vipersat SLM-5650A Guía de usuario Pagina 37