
Sandpiper House, Aviary Court, Wade Road, Basingstoke, Hampshire, RG24 8GX, UK
www.sematron.com
Making waves...
Datasheet
Rev A. Jan 11.
10
7.2 (6.8) 6.8 (6.4) 10.6(10.2)
10
7.8 (7.3) 8.2 (7.8)
Low-Noise Block Converter (LNB) Support
(CDM-570L & CDM-570L-IP Only)
+13, +18, and +24 VDC @ 500 mA maximum
10 MHz via RX center conductor,
-3 dBm ± 3 dB
Block Up Converter (BUC) Support
(CDM-570L & CDM-570L-IP Only)
24 VDC, 90 W @ 50°C, 100 W @ 30°C
(internally fitted option)
48 VDC, 150 W @ 50°C, 180 W @ 30°C
(internally fitted option)
BUC Reference 10 MHz via TX center conductor,
0 dBm ± 3 dB
Via TX center conductor with FSK BUCs
Environmental & Physical
Operating: 0 to 50ºC (32 to 122ºF)
Storage: -25 to 85ºC (-13 to 185ºF)
(See Manual)
CDM-570: 29 W typical (32 W max.)
CDM-570-IP: 37 W typical
CDM-570L: 29 W typical (32 W max.) w/o BUC
CDM-570L-IP: 37 W typical w/o BUC
Dimensions
(height x width x depth)
CDM-570-IP: 1.75” x 19” x 12”
(4.4 x 48.3 x 30.5 cm)
CDM-570L-IP: 1.75” x 19” x 16”
(4.4 x 48.3 x 40.6 cm)
Weight CDM-570 & CDM-570-IP: 6 lbs (2.7 kg)
CDM-570L: 7 lbs (3.2 kg) (without BUC P/S)
CDM-570L & CDM-570L-IP: 16 lbs (7.2 kg) including
150 W BUC power supply
Operations & Maintenance
Configuration and
Management
Remote port – EIA-232 or EIA-485 (2- or 4-wire)
SNMP with MIB II and private, modem-specific MIB
Console interface (EIA-232, RJ-12 connector)
Software/firmware upgrade via FTP
Faults and alarms
Configuration backup and restoral
Security
Accessories
CDM-570L & CDM-570L-IP: 1:1 Modem Redundancy IF Switch
CDM-570 & CDM-570-IP: 1:1 Modem Redundancy IF Switch
CDM-570: 1:N Modem Redundancy IF Switch Module
CDM-570L: 1:N Modem Redundancy IF Switch Module
CDM-570 & CDM-570L: 1:10 Modem Redundancy Switch
Regulatory
CE Mark EMC, Safety (CDM-570 & CDM-570-IP)
EN55022 Class B (Emissions)
EN50082-1 Part 1 (Immunity)
EN60950 (Safety) (CDM-570L & CDM-570L-IP)
FCC Part 15 Class B (CDM-570L & CDM-570L-IP)
Available Options
Variable rate to 2.048 Mbps
Variable rate to 9.98 Mbps
FAST 8-PSK, 8-QAM modulation
(8-QAM with TPC only)
FAST 16-QAM modulation
(requires G.703 E1/T1 interface option)
Hardware G.703 E1/T1 interface
Hardware E1 RAN Optimization
(Requires G.703 E1/T1 interface option)
Power supply, -48 VDC input
Hardware 24 VDC, 90 W @ 50°C (100 W @ 30°C)
BUC power supply, AC input or -48 VDC
input
Hardware 48 VDC, 150 W @ 50°C (180 W @
30°C) BUC power supply, AC input or -
48 VDC input
FAST Header compression
Quality of Service (QoS) – 3 modes
FAST Vipersat Management System
Integration
Networking Protocols
RFC 792 – ICMP RFC 2474 – Diffserv
RFC 856 – Telnet RFC 2597 – AF PHB
RFC 2598 – Expedite Forwarding
2114 West 7th Street, Tempe, Arizon
a 85281 USA
● Voice: +1.480.333.2200 ● Fax: +1.480.333.2540 ● Email: [email protected]Comtech EF Data reserves the right to change specifications of products described in this document at any time without notice and without obligation to notify any person of such changes. Information in this
document may differ from that published in other Comtech EF Data documents. Refer to the website or contact Customer Service for the latest released product information.
© 2010 Comtech EF Data ds-cdm570-IPEN_570L-IPEN.docx 10/29/2010
CDM-570/L-IP Satellite Modem back panel
Comentarios a estos manuales