
www.comtechefdata.com
Comtech EF Data reserves the right to change specifications of products described in this document at any time without notice and without obligation to notify any person of such changes. Information in this
document may differ from that published in other Comtech EF Data documents. Refer to the website or contact Customer Service for the latest released product information.
© 2004 Comtech EF Data Part Number DS-CDM570L.DOC Page 4 of 4 9/22/04
CDM-570L
IP Module
& VMS Inte
ration O
tions
INTRODUCTION
With an innovative architecture to support IP networking, an IP-
Module equipped CDM-570L meets many customer
requirements for Point-to-Point and Point-to-Multi-Point
applications. When configured with the IP Module, the CDM-
570L provides advanced features for improving satellite link
efficiency in IP networks:
STANDARD FEATURES
• easyConnect™ for set up with minimal configuration
• Static IP routing for unicast and multicast
• Powerful network management via SNMP, Web, or Telnet
• IGMP v1 and v2
• Symmetric as well as asymmetric operation for maximum
bandwidth efficiency
• Point-to-Point or Point-to-Multi-Point configuration
OPTIONAL FEATURES
• Header Compression (IP/TCP and IP/UDP/RTP)
• Payload Compression
• 3x DES Data Encryption
• Quality of Service (QoS)
HEADER COMPRESSION OPTION
Configurable on a per route basis, header compression reduces
the required Voice over Internet Protocol (VoIP) bandwidth by
as much as 60%. Example: A G.729 voice codec, operating at 8
kbps, will occupy 32 kbps once encapsulated into IP framing on
a LAN. Using IP/UDP/RTP Header Compression, the same
traffic only needs 10.8 kbps total WAN satellite bandwidth to
cross the link. Normal Web/HTTP traffic can be reduced an
additional 10% via IP/TCP header compression.
PAYLOAD COMPRESSION OPTION
Compressing payload reduces both the data frame size and
satellite bandwidth required to transmit across the link.
Configurable on a per route basis, Payload Compression
optimizes traffic and reduces bandwidth up to 40%.
DATA ENCRYPTION OPTION
The IP Module provides 3xDES data encryption to prevent
unauthorized access to data over the satellite link, and is
configurable on a per route basis.
QUALITY OF SERVICE OPTION
The IP Module supports multi-level QoS to reduce jitter and
latency for real time traffic, provides priority treatment to
mission critical applications and allows non-critical traffic to
use the remaining bandwidth. Three modes are available,
Max/Priority, Min/Max and DiffServ.
• Max/Priority - Assign a maximum bandwidth that any traffic
flow can utilize combined with 8 levels of prioritization
• Min/Max - Set the minimum and maximum bandwidth for
user-defined classes of traffic to ensure that a certain level
of bandwidth is always applied
• DiffServ – Provide higher priority to some applications over
others; Industry-standard method of adding
network-wide QoS enabling seamless co-existence in
networks that already have DiffServ
NETWORKING PROTOCOLS
RFC 768 – UDP RFC 2045 – MIME
RFC 791 – IP RFC 2236 – IGMP v2
RFC 792 – ICMP RFC 2474 – Diffserv
RFC 793 – TCP RFC 2475 – Diffserv
RFC 826 – ARP RFC 2578 – SMI
RFC 856 – Telnet RFC 2597 – AF PHB
RFC 862 – Ping RFC 2598 – Expedite Forwarding
RFC 894 – IP RFC 2616 – HTTP
RFC 959 – FTP RFC 2821 – SMTP
RFC 1112 – IP Multicast RFC 3412 – SNMP
RFC 1213 – SNMP MIB II RFC 3416 – SNMPv2
RFC 1812 – IPv4 Routers RFC 3418 – SNMP MIB
OPERATIONS & MAINTENANCE
Configuration and management
Console interface
SNMP with MIB II and private, modem-specific MIB
Telnet
HTTP
Software / firmware (IP Module) upgrade via FTP
Traffic management statistics
Faults and alarms
Configuration backup and restoral
SECURITY
Password Protection
Access List
CONSOLE PORT
Interface
EIA-232 (RJ-12 connector)
REMOTE PORT
Interface
EIA-232 or EIA-485 (2- or 4-wire)
VMS NETWORK AND BANDWIDTH MANAGEMENT
Vipersat Networks’ VMS provides traditional monitor and
control functions more efficiently than other M & C protocols,
and allows enhanced capacity and bandwidth management
capabilities for the CDM-570L. VMS gives satellite service
providers and enterprise operators the ability to dynamically
adjust bandwidth based on application, load or schedule.
VMS also allows the CDM-570L to switch from shared to
dedicated mode. Inbound transmissions from remotes can be
switched from a shared Selective Time Division Multiple Access
(STDMA) mode to a dedicated Single Carrier Per Channel
(SCPC) connection manually or automatically, triggered by
application or load, or on a scheduled basis. This enables the
network to more effectively handle connection-oriented
applications and reduces both latency and network congestion.
Through VMS, dynamic point-to-point mesh connections can be
established between remotes. The result is an economical and
flexible network, enabling bandwidth to be shared and directed
where it is needed for any mix of IP voice, video or data traffic.
Comentarios a estos manuales