Comtech-ef-data Vipersat Load Utility v3.5.x Manual de usuario Pagina 89

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 106
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 88
Chapter 4 - Using VLoad — Digicast Mode 4-19
Digicast Media Router Remote Commander
Adding a PID
Figure 4-20
Digicast Add PID dialog
PID ID – The identifier for the PID on the receiver. The PID ID is the how to
address the PID from this application to the receiver.
PID Name – A user defined identifier.
PID Value – The value of the PID in hexadecimal format.
VLAN ID – Allows the user to set the Virtual Local Area Network ID to one of
the following: None, All, 4094.
Mode – Allows the user to set the Mode to either Multiprotocol Encapsulation /
Internet Protocol(MPE/IP) or Digital Video Broadcasting - Transport Stream
(DVB-TS).
Destination IP Address – The IP address to be used when routing the Trans-
port Stream over the Ethernet IP.
Port – The Port Number used when routing the Transport Stream over the
Ethernet IP.
Vista de pagina 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 105 106

Comentarios a estos manuales

Sin comentarios